38745109-c1d3-455d-a3d6-14af7e5994bf.jpg

Matek Systems ELRS-R24-P6 R24-P6 ExpressLRS 2.4GHz PWM Receiver With Antenna Support 2~8S VBat Voltage Sense For FPV RC Racing Drone

28,25 

Availability: 2 in stock Category: Vendor: RC&Robots

Description

Matek Systems ELRS-R24-P6 R24-P6 ExpressLRS 2.4GHz PWM Receiver With Antenna Support 2~8S VBat Voltage Sense For FPV RC Racing Drone


Description:

Brand: Matek Systems

Model: ELRS-R24-P6

Item: PWM Receiver

ESP8285, SX1281

Antenna connector: IPEX MHF 1

6x PWM outputs

Support 2~8S VBat voltage sense

RF Frequency: 2.4GHz (2400~2480MHz)

Telemetry power: 12dbm

Receiver output protocol: PWM

Input voltage: 4~9V DC @ “+” pad

Voltage sense: 34V Max. @ “VBat” pad

Power dissipation:  45mA(binding), 85mA(wifi mode)

PCB size: 20mm x 18mm

Weight: 2g w/ antenna

b8f21e52 8f34 445c 8b58 c2cc29c298f7

Firmwares

* ExpressLRS 3.0 or newer, DIY 2.4GHz / DIY 2400 RX PWMP EX.

* ExpressLRS wiki for PWM receiver, Click HERE

* Make sure Receiver and TX module both are running ExpressLRS 3.0 or newer.

——————————————————-

* Receiver has ExpressLRS 3.0 preloaded with binding phrase ‘123456’,  the Receiver will never enter binding mode if using the traditional binding procedure.

* You need to reflash it with your binding phrase OR go into WebUI to set your binding phrase.

Flashing via Wifi

* Disconnect ESC and servos from receiver first.

* Power on receiver by 5V source. Receiver’s LED(Red) will blink slow at first, and after 20s, it should blink fast indicating it’s on Wifi Hotspot Mode.

* More detailed steps,  pls refer this page.

* Target: DIY 2.4 GHz / DIY 2400 RX PWMP EX.

Flashing via UART

* Disconnect ESC and servos from receiver first.

* Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to 5V and GND of the Receiver.

* Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid.

* Select the target DIY 2.4 GHz / DIY 2400 RX PWMP EX  and  “UART” for Flashing Method,  set your bind phrase and Firmware Options and once done, click on Build and Flash.

Package Included:

1x Matek Systems ELRS-R24-P6 Receiver

1x IPEX MHF1 Antennas. 15cm

Dupont 2.54 pins  (Board is shipped unsoldered)

edcba1a3 7e10 4b1c 98ed c1eb7bbd9de8

38745109 c1d3 455d a3d6 14af7e5994bf

Additional information

Weight 0,004 kg

Reviews

There are no reviews yet.


Only logged in customers who have purchased this product may leave a review.

Vendor Information

Vendor: RC&Robots

Company: RC&Robots

Your name: Your email address: Your message: